[oe] Compulab cm-x300 support
brandhetlampje at gmail.com
Mon May 25 09:29:12 CEST 2009
The board hasn't been added because I'm not sure it's done completely
The board recipe seems to work correct for me, but my Linux-kernel recipe
isn't the most elegant yet (does work, but will not be approved for OE
I attached the machine conf, you can use it locally. Kernel I'm currently
using is 2.6.26, pre-patched with Compulab patches. 2.6.29 also in progress,
hope to be able to add that sooner or later in a correct way.
As I've suffered from a JFFS2 bug one two cm-x300 modules, which made the
rootfs corrupt within one reboot (on NAND flash), I'm very curious to your
experience with the module. Rootfs on USB-stick seems to work correct
Siebren Hakkesteegt (tsjsieb)
On Wed, May 20, 2009 at 9:52 PM, Thad Thompson <TThompson at nucsafe.com>wrote:
> Hey Ya'll,
> I'm a newb here, so first let me say that after working with Open
> Embedded for a few days, it is quite the impressive stuff. After setting
> up and maintaining an in-house embedded Linux build system for a while,
> I'm quite over doing it all myself.
> So my question: Does anybody have a working setup for the Compulab
> cm-x300 board yet? I don't find it anywhere in git, but I've noticed
> that it's being built by tsjsieb on Tinderbox. If possible, I'd like to
> see this board in the mainline git tree but don't see any point in
> duplicating work (or stepping on somebody).
> -Thad Thompson
> Openembedded-devel mailing list
> Openembedded-devel at lists.openembedded.org
-------------- next part --------------
A non-text attachment was scrubbed...
Size: 1033 bytes
Desc: not available
More information about the Openembedded-devel