[Angstrom-distro-users] Simpad boot problem

[Guido von Walter]

Actually I'm not sure, I did that installation a while ago. But I  
would I assume I did that, as it is explicitly mentioned in the  
instructions on opensimpad.org. If this is the problem, can I correct  
it? ("eflash root" or something?)

Regards,
Guido.


On Nov 30, 2008, at 18:11 , Bernhard Guillon wrote:

> Guido von Walter schrieb:
>> Hi,
>> I am trying to install Angstrom on my SIMpad SLC but get errors  
>> during boot.
>> I installed the HH-Bootloader, transferred Angstrom-minimalist-gpe- 
>> image-glibc-ipk-2007.12-r18-simpad.rootfs.jffs2 via serial Y-Modem  
>> to the simpad ("load root") and tried to boot.
>> The kernel comes up but shows errors after "setting system  
>> clock" (perhaps first write access?):
>>
> Hi,
> did you erase the flash with the siemens loader before flashing the  
> hh bootloader?
>
> best regards
> Bernhard Guillon
>
>
> _______________________________________________
> Angstrom-distro-users mailing list
> Angstrom-distro-users at linuxtogo.org
> http://lists.linuxtogo.org/cgi-bin/mailman/listinfo/angstrom-distro- 
> users