[Angstrom-distro-users] PCI CF-100TX2 driver will not bind

[Juergen Schinker]

> This card apparently works with the Zaurus. I've only tried it on Angstrom
> so far, with no success.
>
> The linux instructions in the manual refer to the /etc/pcmcia/config file,
> which I know is no longer relevant as Angstom uses a 2.6 kernel.
> Everything
> I've found online also only refers to the 2.4 config.
>
> My udev knowledge is pretty bad. So far, I've figured that I might have
> some
> luck with the /lib/modules/2.6.22/modules.alias file, but I can't figure
> any
> further than that.
>
> Any suggestions?
>

yes i'm also begging for this to be done

check

http://bugs.openembedded.org/show_bug.cgi?id=2409


Regards Juergen