[Angstrom-distro-users] h4000 port stops at boot with "got cmd QUIT"

[Frederik Kunz]

Hi,

I'm trying to run Angström on my iPaq h4150. I installed it onto my SDcard using the rescue system. It boots up and after a while the splash progress bar disappears and I see a lot of log messages. It ends with

psplash.c:91,parse_command() got cmd PROGRESS 99
psplash.c:76,psplash_draw_progress() total w: 222, val :99, w: 219
psplash.c:91,parse_command() got cmd QUIT

Then it stops.

What could this be?

Regards,

Frederik